User’s Manual
12-13
Additional Information
(3) Click
Start
, Settings, System, then Wireless LAN Utility Manager
to get into Manager Page and enable the “Enable Power Saving
Mode,” and then tap
Apply
.
F5: How do I make sure that the Wireless LAN SW has been installed
successfully and that Wireless LAN already work properly?
(1) Please check if the “IEEE 802.11b WLAN Adapter” already exist
in Start, Settings, Connections, Network Adapters; if not, the
Wireless LAN Driver is not Installed successfully.
(2) Please check if the Wireless LAN Utility already exist and could
be opened successfully by simply click Start, Settings, System,
then Wireless LAN Utility.
(3) Click Start, Settings, System, Wireless LAN Utility, Link to check
the current Link information in the Link Page.
Error Messages for Bluetooth
This section explains the causes of and solutions for the various displayed
error messages.
Error messages during COM/DUN service
An error has occurred with the Bluetooth SD Card. Confirm that the
card is working properly.
Cause
There was an error when loading the driver.
Solution Try reinserting the Card.
Unable to retrieve Local Device information.
Solution Reset the Toshiba Pocket PC.
Unable to retrieve Local Device information due to insufficient
memory. Check the amount of available memory.
Solution Reset the Toshiba Pocket PC, increase the memory, and then
restart Bluetooth Settings.
Remote device search failed due to insufficient memory. Check the
amount of available memory.
Solution Increase the memory and then try the remote device search
again.
(1)
Turn off the Wireless LAN Switch will cause the disconnection of the
Wireless Network, please make sure to close all the Wireless
Connection before you execute this function.
(2)
The Turn Off function on the TMU icon will cause the disconnection
of the Wireless Network, please make sure to close all the Wireless
Connection before you execute this function.
(3)
Enable “Power Saving Mode” will keep the connectivity but will
lower down the average throughput due to longer connection period
for the Wireless Network.
(4)
If you are in 802.11 Ad Hoc Mode, you are not allowed to enable
“Power Saving Mode”, because Ad Hoc Mode doesn’t support this
function.