Toshiba MW 27FP1, Руководство по обслуживанию

Страница: 38 / 105

WHEN REPLACING EEPROM (MEMORY) IC
If a service repair is undertaken where it has been required to change the MEMORY IC, the following steps should be taken to
ensure correct data settings while making reference to TABLE 1.
NOTE: No need setting for after INI 44 due to the adjustment value.
C4-1
3.
4.
5.
6.
7.
8.
9.
10.
11.
The unit will now have the correct DATA for the new MEMORY IC.
Table 1
1.
2.
Fig. 1
ADDRESS is now selected and should "blink". Using the UP or DOWN button on the remote, step through the ADDRESS until
required ADDRESS to be changed is reached.
Press ENTER to select DATA. When DATA is selected, it will "blink".
Again, step through the DATA using UP or DOWN button until required DATA value has been selected.
Pressing ENTER will take you back to ADDRESS for further selection if necessary.
Repeat steps 3 to 6 until all data has been checked.
When satisfied correct DATA has been entered, turn POWER off (return to STANDBY MODE) to finish DATA input.
After the data input, set to the initializing of shipping.
Turn POWER on.
Press both VOL. DOWN button on the set and the Channel button (1) on the remote control for more than 2 seconds.
After the finishing of the initializing of shipping, the unit will turn off automatically.
Enter DATA SET mode by setting VOLUME to minimum.
Press both VOL. DOWN button on the set and the Channel button (6) on the remote control for more than 2 seconds.
ADDRESS and DATA should appear as FIG 1.
INIT 00 0F
POWER ON 0010
PLAY/REC 0003
ADDRESS DATA
0F 47 52 02 04 9D 20 22 86 45
+0 +1 +2 +3 +4 +5 +6 +7 +8 +9
+A
+B +C +D +E +F INI
20 E3 52 03 87 00 48 00 F6
9A 97 8C A5 B7 88 91 B6 1A 0B
05 31 18 40 00
D0 08 A6 A1 42 45 00
10
30
15 4B 16 54 83 B2
3D 04 37 16 27 30
30
20
88 89 88 00 00 40
3F 00 23 FF FF FF 80 88 83
EF 0D
--- --- --- --- --- --- --- --- ---
--- ---