Introduction
10
Operation:
• Aim the remote control at the remote sensor and press control buttons to
operate.
• Operate the remote control within 30° angle on either side of the remote
sensor, up to a distance of approx. 5 meters.
Replace the compartment
cover.
Install two “R03/AAA” batteries
(supplied), paying attention to the
polarity diagram in the battery
compartment.
Open the battery compart-
ment cover in the direction of
the arrow.
The precautions below should be followed when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Re-
versed batteries may cause damage to the device. To avoid a potential short circuit, insert the “–” end first.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from
possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery
manufacturer’s directions.)
• Press POWER to turn the unit on or off.
• Tap CH or to move through the channels one channel at a time.
• The Direction buttons (
▲
/
▼
/
B
/
A
) are also used to navigate on-screen menu system.
• You can directly access specific channels using Direct channel selection buttons.
1
2
3
Remote control basics
Inserting batteries
Approx. 5 meters
Identification of controls (continued)
Illustration of MV13Q41
5S20101A [E]p06-10
12/16/04, 4:27 PM
10
