SMMS-i
Owner’s Manual
EN
SMMS-i
Owner’s Manual
– 16 –
1-way cassette type
(YH series)
Vertical adjustment
Horizontal adjustment
NOTE
To improve the cooling/heating performance, change
the louver angle for each running mode.
Floor standing type
Vertical adjustment
Horizontal adjustment
▼
When cooling
Point the louver horizontally to send cool air across the
entire room.
▼
When heating (for heat-pump model only)
Point the louver downward to send heated air to the
floor.
To send air horizontally, point the vertical grilles inside
the louver in your preferred direction.
▼
When cooling
Move the louver manually and point it horizontally to
send cool air across the entire room.
▼
When heating (for heat-pump model only)
Move the louver manually and point it downward to
send heated air to the floor.
▼
Sending air in different directions
Lift up the vertical louvers slightly and point them in
your preferred directions.
1
2
In this case, do not use the
auto swing function.
Floor standing Cabinet type
◆
Changing the air discharge
Follow the procedure below to change the air
discharge:
1
Remove the two fixing screws of the air
discharge. (The fixing screws are to be
reused)
2
Insert your hand into the air discharge and
pull it up slightly, then remove the air
discharge from the claw hook at the rear
side.
3
Lift up the air discharge and remove it.
4
Reverse the air discharge and reattach it to
the main unit.
Make sure that the four claw hooks (2 at the rear
and 2 at the lower sides) are hooked into the
mounting positions.
5
Be sure to tighten the air discharge with the
removed fixing screws so that it does not
come off.
▼
When cooling
Move the louver manually and point it horizontally to
send cool air across the entire room.
▼
When heating (for heat-pump model only)
Move the louver manually and point it downward to
send heated air to the floor.
31-EN
32-EN
+00EH99936401.book Page 16 Thursday, August 26, 2010 6:52 PM
