Toshiba MK8016GSG, Инструкции по установке

Страница: 1 / 4

MK**16GSG Hard Disk Drive Installation Notes P/N 480097-A0 P/N 480097-A0 MK**16GSG Hard Disk Drive Installation Notes
04/08 04/08
TOSHIBA STORAGE DEVICE DIVISION
MK**16GSG Series
HDD INSTALLATION NOTES
© 2008 Toshiba America Information Systems, Inc.
Contents subject to change without prior notice.
GENERAL DESCRIPTION
Toshiba’s MK1216GSG (HDD1F01) and MK8016GSG (HDD1F02) hard disk drive’s
integrate the Serial ATA interface and 5400 RPM rotational speed into a compact, 1.8-
inch footprint, furthering the evolution of mobile PCs into smaller and performance-
enhanced, ultra-portable systems.
SPECIFICATIONS MK1216GSG MK8016GSG
HDD1F01 HDD1F02
FORMATTED CAPACITY 120GB 80GB
HEIGHT 8 m m 8 m m
WEIGHT 62g 62g
NO. OF DISKS (PLATTERS) 2 2
NO. OF DATA HEADS 4 4
FUNCTIONAL SPECIFICATION
LOGICAL DRIVE MK1216GSG/MK8016GSG
PARAMETERS HDD1F01/HDD1F02
NO. OF CYLINDERS (user) 79,488
BYTES PER SECTOR 512
BUFFER SIZE 8MB
ROTATION SPEED (±0.1%) 5,400rpm
TRANSFER RATE INTERNAL 227 - 489Mbits/sec (typical)
NO. OF CYLINDERS (logical) 16,383
NO. OF HEADS (logical) 1 6
NO. OF SECTORS/TRACK 6 3
HOST TRANSFER RATE 1.5Gbits/sec
SEEK TIME
AVERAGE 15ms
TRACK-TO-TRACK 3ms
MAXIMUM 26ms
TEMPERATURE
OPERATING 41°F - 131°F (5°C - 55°C)
NON-OPERATING -4°F - 149°F (-20°C - 65°C)
HUMIDITY
OPERATING/NON-OPERATING 8 - 90% R.H. (No condensation)
SHIPPING 5 - 90% R.H. (No condensation)
WET BULB 29°C(operating)/40°C(non-operating)
CONNECTOR CABLING INFORMATION
The following table describes all of the pins on the Serial ATA connector:
Signal Segment Key
S1 GND 2nd mate
S2 A+ Differential Pair A from PHY
Signal S3 A-
Segment S4 GND
S5 B- Differential Pair B from PHY
S6 B+
S7 GND 2nd mate
Signal Segment “L”
Central Connector Polarizer
Power Segment “L”
P1 V33 3.3V Power
P2 V33 3.3V power pre-charge
P3 GND
Power P4 GND
Segment P5 V5 5V Power pre-charge 2nd mate
P6 V5 5V power
P7 Reserved*
P8 Optional
P9 Optional
Power Segment Key
* The corresponding pin to be mated with pin P7 in the power Internal Micro receptacle.
Connector shall always be grounded.
Notice: this drive uses 3.3V power only. 5V power is not used.