DISASSEMBLY INSTRUCTIONS
B2-1
2. REMOVAL OF DVD DECK PARTS
2-3:
2-4:
Remove the screw
1
.
Remove the Lever Switch.
Remove the 2 Insulator (R).
Press the Clamper and rotate the Clamper Plate clockwise,
then unlock the 3 supports
2
.
Remove the Clamper Plate, Clamper Magnet and Clamper.
1.
2.
3.
4.
5.
Fig. 2-4-A
Press down the catcher
1
and slide the Rack Loading.
Remove the Rack Loading, Rack Loading Spring and
Main Gear.
1.
2.
Fig. 2-3
Main Gear
RACK LOADING/MAIN GEAR/ RACK LOADING
SPRING (Refer to Fig. 2-3)
1
Rack Loading
Rack Loading Spring
Main Frame Ass'y
CLAMPER ASS'Y/INSULATOR(R)/LEVER SWITCH
(Refer to Fig. 2-4-A)
Main Frame
Clamper Plate
Clamper Magnet
Clamper
1
Lever Switch
Insulator (R)
(Green)
NOTE
1.
2.
3.
4.
When installing the Clamper Magnet, install it with the
green face up.
When installing the wire of the Lever Switch, install it
correctly as Fig. 2-4-B.
When installing the Lever Switch, install it correctly as
Fig. 2-4-C.
In case of the Lever Switch installation, hook the wire on
the Main Frame as shown Fig. 2-4-D.
2
2
2
Fig. 2-4-B
Insulator (R)
(Green)
2-1: TRAY (Refer to Fig. 2-1-A)
Set the Tray opened. (Refer to the DISC REMOVAL
METHOD AT NO POWER SUPPLY)
Unlock the support
1
and remove the Tray.
1.
2.
Fig. 2-1-A
Tray
Main Frame Ass'y
1
NOTE
1. In case of the Tray installation, install them as the circled
section of Fig. 2-1-B so that the each markers are met.
2-2: MAIN CHASSIS ASS'Y (Refer to Fig. 2-2)
Remove the Main Chassis Ass'y from the Insulator (R).
Unlock the support
1
.
Remove the Main Chassis Ass'y.
1.
2.
3.
Fig. 2-2
Main Frame Ass'y
Main Chassis Ass'y
1
Tray
Main Frame Ass'y
Fig. 2-1-B
Insulator (R)
(Green)
NOTE
1. Do not disassemble the DVD DECK PARTS except listed
parts here. Minute adjustments are needed if the
disassemble is done. If the repair is needed except listed
parts, replace the DVD MECHA ASS'Y.
Lever Switch
Red
White
Blue
From DVD PCB
