5
Outdoor unit
34
5-8.
Applied control for Outdoor Unit
The outdoor fan high static pressure support function is made available by setting relevant switches provided on the
interface P.C. board of the outdoor unit.
5-8-1. Outdoor Fan High Static Pressure Shift
units.
nnected outdoor unit for both of the header and follower
This function must be enabled with every discharge duct co
on the interface P.C. board of the outdoor unit.
Turn ON the DIP switch [SW10, Bit 2] provided
Setup
installation on the floor by floor installation.)
e port of an outdoor unit (as part of, for example, unit
This function is used when connecting a duct to the discharg
Purpose/characteristics
Specification
Increase the speed of the propeller fan units on the outdoor fan to allow the installation of a duct with a maximum
external static pressure not greater than specified in the table below. If a discharge duct with a resistance greater
than 0.0 inWG (1. mmAq) is to be used,enable this function. The maximum external static pressures of
units are shown below (Table 1).
(Table 1.) Maximum external static pressures of outdoor units
0.
(CFM)
Model name
Maximum external static pressure
0
Outdoor unit air flow
(inWG)
0.
0.
MY-MAP0 H-UL
MY-MAP0H-UL
MY-MAP0H-UL
E16-3P1_databook.book Page 34 Tuesday, December 20, 2016 3:02 PM