3
Placing Hard Drive inside your Computer
•
Determine mounting configuration (the drive can be mounted in either a horizontal or vertical
orientation)
•
Configure drive for system application.
•
Configure the adapter board for the specific system application (if required).
•
Install adapter board into an unused PC/AT 16 bit slot (if required).
•
Install the I/F cable to the system's 44 pin connector port or adapter board. Ensure pin 1 is
oriented correctly, (pin 1 on the cable is usually identified by a red or blue strip.)
•
Set correct drive type in system CMOS
•
Refer to applicable manuals for software installation instructions.
Important Note: Disconnect power from your computer system before beginning installation.
Figure 2.HDD Mounting Holes
