TTEI CODE : RFFP09082431000
MDM - 04 '20 V2
- 5 -
- 6 -
- 7 -
- 8 -
Shade
Lamp
Lamp Socket
Screw
(1) BEFORE TAKING OFF LAMP NEED TO TAKE OFF ELECTRICAL PLUG FIRSTLY
TAKE LAMP OFF BY TURN COUNTERCLOCKWISE.
REPLACE A NEW LAMP (E14 / 15 W) BY TURN CLOCKWISE.
RE-ASSEMBLY AND FIXING SHADE BY SCREW
USE A SCREWDRIVER TO TAKE OFF SCREW FIXED A SHADE
TAKE SHADE OUT BY SLIDING TO THE RIGHT AND PULL UP
CAUTION
BEFORE CLEANING THE REFRIGERATOR, MUST BE TAKE OUT AN ELECTRIC PLUG
FOR CLEANING THE CONTROL BOX SHOULD BE USE A SOFT DRY CLOTH. DO NOT CLEAN IT
DO NOT USE BRUSHES, ACIDS, CHEMICAL,AND THINNER FOR CLEANING OF REFRIGERATOR.
SHOULD CLEAN THE FREEZER COMPARTMENT EVERYTIME WHEN YOU DEFROSTED.
OUTSIDE AND INTERIOR PARTS OF REFRIGERATOR
IF THERE IS DIRTY POSITION, USING WARM WATER AND CLOTH TO CLEAN IT OUT. BUT IF IT
TOO STRONG. MIX WARM WATER WITH A FEW OF SOPE TO CLEAN IT OUT THEN FOLLOW
GASKET
DOOR
AT LEAST 2 WEEKS FOR CLEANING, USING SOFT BRUSH AND WARM WATER CLEAN IF SOFTLY
FOLLOW BY SOFT AND CLEAN CLOTH
.
BY CLEAN COLTH. ON THE HANDLE, USE A DRY CLOTH TO CLEAN.
WITH WATER MAY CAUSE AN ELECTRIC SHOCK.
CAUTION
ANNUALLY CLEANING
THIS REFRIGERATOR IS CYCLOPENTENE INSULATION AND REFRIGERANT IS R600a
SHOUL BE KEPT AWAY FROM HEAT OR FLAME WHEN IT ISN'T PROPERLY USED.
DISPOSAL OF REFRIGERATOR SHALL BE DONE IN ACCORDANCE WITH THE NATIONAL
OR LOCAL REGULATIONS. MORE DETAILS PLEASE CONTACT YOUR LOCAL CITY OFFICE
WHEN YOU WANT TO DISPOSE THIS FRIDGE MUST TAKE OFF THE DOOR OR
REMOVE GASKET FROM THE DOOR FIRSTLY.
OR YOUR HOUSEHOLD WASTE DISPOSAL SERVICE.
DISPOSE THE REFRIGERATOR
PLEASE CONTACT WITH ENVIRONMENTAL PROTECTION UNIT TO DEAL WITH DISCARD
CYCLOPENTANE INSULATION AND R600a REFRIGERANT
HOW TO REPLACE LAMP
(2) KEEP TIGHTEN WHEN MONTING WITH LAMP SOCKET, BECAUSE THIS REFRIGERATOR
CONTAINS REFRIGERANT IS R600a, WIHICH IS FLAMABLE MATERIAL
(3) PLEASE BE CAREFUL WHEN YOU TOUCH LAMP, IT WILL BE HIGH TEMPERATURE
(4) PLEASE DON'T USE REFRIGERATOR WITHOUT LAMP OR REPLACEMENT NOT COMPLETE
CAUTION
DO NOT USE HOT WATER OR SHARP-END TOOLS TO GET RID OF ICE COVERING
THE EVAPORATOR. WE WOULD NOT BE RESPONSIBLE FOR THE CLAIMS, IF THIS KIND
OF INCIDENT OCCUR.
LEAVE ROOM BETWEEN CONTAINERS AND FOODS. OVERLOADING THE REFRIGERATOR
WILL DECREASE THE COOLING EFFICIENCY.
COOLING HOT DISHES TO ROOM TEMPERATURE BEFORE PLACING IN REFRIGERATOR.
DO NOT KEEP THE DOOR OPEN ANY LONGER THAN NECESSARY, TO PREVENT
COOLING EFFICIENCY DECREASE.
PRESS THE DEFROST BUTTON FOR AN IMMEDIATE CUT OFF THE COOLING SYSTEM.
SECOND STEP
WATER FROM MELTING ICE WILL BE CONTAINED IN A DRAIN PAN. WHEN DEFROSTING
PROCESS IS COMPLETED, THE COOLING SYSTEM WILL AUTOMATICALLY RE-START.
THIRD STEP
THE WATER FROM DEFROSTING PROCESS WILL DROP TO
THE DRAIN PAN AT BACK SIDE OF REFRIGERATOR AND WATER
DISCONTINUE OF DEFROST PROCESS
SIMPLY TURN KNOB TO NORMAL POSITION OR YOUR PREFER COOLING, OR PULL BACK
THE DEFROST BUTTON AS MENTIONED MODEL. BUT, MAKE SURE TO ALLOW
AT LEAST 5 MINUTES AFTER THE DEFROST START.
WHEN AN ICE COVERING THE INSIDE OF AN EVAPORATOR
IS THICKER THAN 5-10 MM OR THE DEFROST MARKING
LEVEL (AS PICTURE), FOLLOW THESE INSTRUCTIONS.
FIRST STEP
STORED FOODS SHOULD BE BRING OUT FROM INSIDE THE EVAPORATOR.
PERISHABLE FOODS SHOULD BE STORED IN COOL PLACE.
DEFROST
MARKING LEVEL
DEFROSTING METHOD
DRAIN PAN BACK
HOW TO USE THE REFRIGERATOR
WILL EVAPORATION IS AUTOMATIC.
INSTALLATION
ALLOW AT LEAST 10 CM (4 INCHES) FROM SIDES AND 30 CM (12 INCHES)
VERTICALLY FOR PROPER AIR CIRCULATION.
INSTALL TOSHIBA REFRIGERATOR ON A STRONG AND LEVEL FLOOR.
TO PROTECT THE REFRIGERATOR FALL DOWN
WHEN OPENING THE REFRIGERATOR DOOR.
USE SOME INSTRUMENT TO HOOK AT THE
HOLE OF BACK SIDE AS PICTURE.
INSTALL TOSHIBA REFRIGERATOR AWAY FROM HEAT, WET AND DAMP AREAS.
DO NOT INSTALL CLOSE TO A SINK OR CLEANING MACHINES THAT MIGHT DAMAGE
THE REFRIGERATOR BY CAUSING RUST AND ELECTRICAL LEAKAGE.
KEEP THE REFRIGERATOR AWAY FROM SUNLIGHT OR HEAT
EMITTING OBJECTS. THE REFRIGERATOR WILL HAVE ITS
COOLING EFFECT REDUCED AND A FAILURE MIGHT BE CAUSED.
LOCATION
HOW TO USE THE REFRIGERATOR
TEMPERATURE CONTROLS
NORMALLY, WE SET THE CS KNOB AT COOLING LEVEL 3~4. BUT YOU CAN SELECT
A COOLING LEVEL AS YOU PREFER.
DEF.PUSH BUTTON
CS KNOB
COOLING LEVEL
INSIDE TEMPERATURE
0 (OFF)
TURN OFF
1 - 2
LOW COOL
NORMAL COOL
HIGH COOL
3 - 4
5 - MAX.
WHEN POSITIONING THE APPLIACE, ENSURE THE SUPPLY CORD IS NOT TRAPPED
DO NOT LOCATE MULTIPLE PORTABLE SOCKET-OUTLETS OR PORTABLE POWER SUPPLIES
AT THE REAR OF THE APPLIANCE
OR DAMAGED
WARNNING
MOVING METHOD
MUST TAKE OFF AN ELECTRICAL PLUG BEFORE MOVE
●
DO NOT LAY THE REFRIGERATOR ON ITS SIDES
●
HOLD THE REFRIGERATOR AT BOTTOM SIDE, WHEN MOVING IT
●
FIRSTLY, REMOVE FOOD OR ITEMS THAT KEEP INSIDE
●
SHOULD BE DRAIN OUT WATOR IN DRAIN PAN BACK AND CLEAN UP
●
TAKE OFF AN INTERIOR PART OR USE TAPE STICK TO FIX POSITIOPN BEFORE MOVE
●
USE TAPE STICK AT DOOR AND CABINET TO PREVENT DOOR OPEN WHILE MOVING
●
SHOULD BE MOVING THE REFRIGERATOR BY 2 PERSONS
