Toshiba GR 200 Series, Инструкция по эксплуатации

Страница: 234 / 1563

6F2S1915 (0.46)
GRZ200 (Soft 031 & 032)
- 213 -
2.8.2
Thermal characteristic
THM characteristics are determined with two equations. Equation (2.8-3) is used to define the
cold state. Equation (2.8-4) is used to define the hot state:
t = τ ∙ Ln [
𝐼
2
𝐼
2
− 𝐼
𝐴𝑂𝐿
2
]
(2.8-3)
t = τ ∙ Ln [
𝐼
2
− 𝐼
𝑃
2
𝐼
2
− 𝐼
𝐴𝑂𝐿
2
]
(2.8-4)
where t is time to trip for a constant overload current of I (minutes), I is the overload current
(largest phase current in amperes), I
AOL
is the permitted overload current (amperes), Ip is the
pre-load current (amperes), τ is the thermal time constant (minutes), and Ln is the natural
logarithm.
In Equation (2.8-3), cold curves are special versions of the hot curves where Ip is zero,
catering for the situation where a cold system is switched onto an immediate overload.
Figure 2.8-1.a shows the cold state where an overload has been switched onto a previously
un-loaded system. Figure 2.8-1.b shows the hot state where an overload is switched onto a
system that has previously been loaded to 90% of its capacity. The figures are in conformity
with the IEC 60255-149 curves, and these curves are drawn in a range of settings of the time
constant (

).
a.Thermal Curves (Cold Curve - no prior load) b. Thermal Curves (Hot Curve - 90% prior load))

100
50
20
10
5
1
Figure 2.8-1 Thermal curves