Toshiba FT-8859, Руководство по обслуживанию

Страница: 5 / 57

3
ALIGNMENT PROCEDURE
Test Mode For Base Unit
Press the " " and "#" keys at the same time about 2 seconds while turning the power on, the confirmation beep
will sound to indicate that the unit is in the test mode.
1. To change the TEST mode: Press the number key for the corresponding TEST mode.
(Refer to the following table)
2. To change channel: Press the "RDL" key, but if changing the step, the channel returns to the start
channel.
3. To cancel Test mode: Bell rings (except for Step 6), charge the Handset (except for Step 9) or Power
off.
*1 : “0000...” (250Hz) will be fed out continuously as transmitting data.
*2 : Bell rings and INTCOM LED lights when sensing SQ.
-6#= (YHU\ # SXVKLQJ # RI # )/$6+ # NH\ # PDNHV # WRQH # FKDQJH 1#+ ,Q # WKH # FDVH # RI # 'XDO # 7RQH /# FKDQJHV # DV
4 Ö 5 Ö 6 Ö 7 Ö 8 Ö 9 Ö : Ö ; Ö < Ö 3 Ö
∗
Ö & Ö 41,
DTMF Frequency
ROW1 : 697 ROW2 : 770
ROW3 : 852 ROW4 : 941
COL1 : 1209 COL2 : 1336
COL3 : 1477
*4 : Bell rings when the received data are “0000...” (250Hz).
*5 : Charge LED lights when detecting Charge ON.
Channel rotation
4<# Ö 53 Ö 54 Ö 73 Ö 4 Ö 5 Ö 6 Ö 7 Ö 81111111111116: Ö 6; Ö 6< Ö 73
STEP FUNCTION KEY START CH TX CONT TX MUTE RX MUTE RL CONT REMARKS
1 VO/TX FRQ. ADJ 1 19 L L L L
2 TX MODE CHECK 2 19 L H L H
3 TX DATA 3 19 L L L L *1
4 RX SENS. 4 19 H L H H
5 SQ SENS. 5 19 L L H/L H *2
6 RING CHECK 6 19 H L L L
7 DUAL TONE CHECK 7 19 H L L H *3
8 DATA IN CHECK 8 19 L L L H *4
9 CHANNEL DATA CHECK 9 19 H L L L *5
10 DUPLEX 0 19 L H H H
11 INT COM MEM 19 L H H L