Toshiba FT-3809 BK, Руководство по обслуживанию

Страница: 5 / 60

4
ALIGNMENT PROCEDURE
Perform the alignment of the Handset & Base using the test mode described below:
1. Test mode for Handset unit:
1.1 Connecting the 3.6VDC power supply to the battery contact.
1.2 Pressing the “#” and “3” keys at the same time for twice, “TALK/BATT LOW”
LED will be on.
1.3 To change channel, press the CHANNEL key.
1.4 To toggle TX power , press the PROG key.
1.5 To toggle RX power, press the key.
1.6 To toggle TX attenuater, press the REDIAL key.
1.7 To change PLL gain mode, lowest (4 steps)
!
highest, Press the PHONE key.
1.8 Pressing OFF key to exit from test mode.
1.9 LED indication.
TALK/BATT LOW “ON”
TX power on
2. Test mode for Base unit:
2.1 Apply AC power by connecting the AC adaptor to Base unit, Pressing and hold the
PAGE button at same time, then, slide the TONE/PULSE switch from PULSE to
TONE to enter test mode, The IN_USE LED and the CHARGE LED will
illuminate.
2.2 Change Mode:
Press and hold the PAGE button for 1-2 seconds. You will change to the next mode.
once the charge LED change state (ON
!
OFF or OFF
!
ON).
MODE Charge LED Function Press PAGE button
1 ON Change RF channel 1-30 (default 6)
2 OFF Toggle RF transmitter power Default on
3 ON Unused
4 OFF Generate single tone from
DTMF table for 3 seconds,
There are 8 tones in the table. 697, 770, 852, 941, 1209,
1336, 1477, 1633 Hz default
is 697Hz.