6
PRECAUTIONS
• For stubborn dirt, soak the cloth in a weak detergent
solution, wring well and wipe. Use a dry cloth to wipe it
Notes on handling
Notes on locating
Inspection and Maintenance
Notes on moisture condensation
Moisture condensation damages the Symbio™ Media
Box and Blu-ray Disc™ Player. Please read the following
carefully:
Moisture condensation occurs during the following
cases.
Notes on cleaning
This unit is a high technology, precision device. If the
optical pick-up lens and disc drive parts become dirty or
worn down, the picture quality may be reduced. To avoid
reduction in picture quality, it is recommended that regular
inspection and maintenance (cleaning or parts replacement)
be performed every 1,000 hours of use. For further details,
contact your nearest consumer electronics dealer.
• Moisture condensation occurs, for example, when you
pour a cold drink into a glass on a warm day.
• Drops of water form on the outside of the glass.
• In the same way, moisture may condense on the optical
pick-up lens inside this unit, one of the most crucial
internal parts of the unit.
• When you bring the unit directly from a cold place to a
warm place.
• When you use the unit in a room where you just turned
on the heater, or a place where the cold wind from the air
conditioner directly hits the unit.
• In summer, when you use the player in a hot and humid
place just after you move the unit from an air conditioned
room.
• When you use the player in a humid place.
Use a soft, dry cloth for cleaning.
• When shipping the unit, the original shipping carton
and packing materials come in handy. For maximum
protection, repack the unit as it was originally packed at
the factory. Take care not to give it a shock or shake when
carrying.
• Do not use volatile liquids, such as insect spray, near the
unit. Do not leave rubber or plastic products in contact
with this unit for a long time. They will leave marks on the
finish.
• The top and rear panels of the unit may become warm
after a long period of use. This is not a malfunction.
• When the unit is not in use, be sure to remove the disc
and turn off the power.
• If you do not use the unit for a long period, the unit may
not function properly in the future. Turn on and use the
unit occasionally.
Place the unit on a level surface. Do not use it on a shaky
or unstable surface such as a wobbling table or inclined
stand. The loaded disc may come off the proper position
and cause damage to the unit.
When you place this unit near a TV, radio, or VCR, the
playback picture may become poor and the sound may
be distorted. In this case, place the unit away from the TV,
radio, or VCR.
Do not use this unit in places which are extremely hot, cold,
dusty or humid.
Do not restrict the air flow of this unit by placing it
somewhere with poor air flow, by covering it with a cloth,
or by placing it on bedding or carpeting.
Be sure to remove the disc and unplug the AC power cord from
the outlet before carrying the unit.
Wireless Radio
FCC Radiation Exposure Statement
For product available in the USA/Canada market, only
channel 1-11 can be operated. Selection of other channels
is not possible. The device could automatically discontinue
transmission in case of absence of information to transmit,
or operational failure. Note that this is not intended to
prohibit transmission of control or signaling information
or the use of repetitive codes where required by the
technology. If this device is going to be operated in 5.15-
5.25GHz frequency range, then it is restricted to an indoor
environment only.
This equipment complies with FCC radiation exposure limits
set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance
20cm between the radiator & your body
Important: Any changes or modifications not expressly
approved by the party responsible for compliance could void
the user’s authority to operate this equipment. This device
and its antenna(s) must not be co-located or operating in
conjunction with any other antenna or transmitter.
dry. Do not use any type of solvent, such as thinners and
benzene, as they may damage the surface of the unit.
• If you use a chemical saturated cloth to clean the unit,
follow that product’s instructions.
