6. APPENDIX 1 INTERFACE
ENGLISH VERSION
6. APPENDIX 1 INTERFACE
E6-1
6. APPENDIX 1 INTERFACE
USB interface (Standard)
Standard:
Conforming to V2.0 High speed
Transfer type:
Control transfer, Bulk transfer
Transfer rate:
480M bps
Class:
Printer class
Control mode:
Status with the receive buffer free space information
Number of ports: 1
Power source:
Self power
Connector:
Type A and Type B
Pin No.
Signal
1
VCC
2
D-
3
D+
4
GND
LAN (Standard)
Standard:
IEEE802.3 10BASE-T/100BASE-TX
Number of ports: 1
Connector:
RJ-45
LED status:
Link LED
Activity LED
LAN cable:
10BASE-T: UTP category 3 or category 5
100BASE-TX: UTP category 5
Cable length: Segment length Max. 100 m
LED
LED Status
LAN status
Link
ON
10Mbps link or 100Mbps link is detected.
OFF
No link is detected.
* Communication cannot be made while
the Link LED is off.
Activity
ON
Communicating
OFF
Idle
Link LED(Green)
Activity LED (Orange)
NOTE:
To prevent radiation and reception of electrical noise, the interface cables must meet the following requirements:
•
In case of a parallel interface cable or serial interface cable, fully shielded and fitted with metal or metallised
connector housings.
•
Keep as short as possible.
•
Should not be bundled tightly with power cords.
•
Should not be tied to power line conduits
.
•
A parallel interface cable to be used should conform to IEEE1284.