E-7
2. Leaving plenty of slack between the ribbon spools, place the ribbon onto the Ribbon Shafts as
shown below. There are 2 possible ways to load the ribbon.
3. Slide the Ribbon Stoppers along the Ribbon Shafts to a position where the ribbon is centred
when fitted.
4. Lower the Print Head Block and set the Ribbon Shaft Holder Plate aligning its holes with the
Ribbon Shafts.
5. Take up any slack in the ribbon. Wind the leading tape onto the ribbon take-up roll until the ink
ribbon can be seen from the front of the printer.
6. Turn the Head Lever to Lock position to close the Print Head.
7. Close the Top Cover.
Print Head Block
Ribbon Shaft
Ribbon Shaft
Holder Plate
Ribbon Shaft
Outside Wound Ribbon
Inside Wound Ribbon
NOTE:
To check or change settings on which type of Ribbon winding to be used, you must go to SYSTEM Mode in
the Printer. For more detail refer to
Key Operation Specification, “8.4.1 PRINTER SET”
.
