E12-1
12. LED DISPLAY AND TROUBLESHOOTING
ENGLISH VERSION EO1-33014
Close the cover
Close the cover after
installing a label.
Close the cover after
installing a label.
Close the cover
(See NOTE)
Stop issuing labels for
a while.
(See NOTE)
(See NOTE)
Replace the battery,
or charge the battery.
Close the cover
Close the cover after
installing a label.
Form Entry, Area
Format
Replace the battery.
12. LED DISPLAY AND TROUBLESHOOTING
12. LED DISPLAY AND TROUBLESHOOTING
WARNING!
If you cannot solve a problem with the following solutions, do not attempt to repair the printer
yourself. Turn off the printer, then contact your authorized TOSHIBA TEC representative for
assistance.
When a problem occurs during operation, the LED indicator will blink or stay on continuously. Refer to
the following troubleshooting guide and take corrective action.
Printer Status
When the power is turned on.
Normal Condition
While the cover is open.
Command Error
Feed jam
Label End
Cover Open Error
Thermal Head Disconnection Error
Thermal Head Abnormal High
Temperature
Flash ROM Data Writing Error
Flash ROM Data Erasing Error
Low-battery
In action
Communication Error
Normal Termination and Label
End
Form entry area in the flash ROM
becomes full.
Normal Termination
Battery Life Error
LED Display
ERROR
BATTERY
Condition to clear the
ERROR Status
*
LED flashing repeats ON and OFF at the interval of 0.1 sec.
*
When the printer goes into energy-saving mode, the LED will be extinguished to save energy. How-
ever, when normal operation mode is resumed, the LED will flicker or illuminate again.
*
If the printer status changes during an error, the LED display will also change to indicate the latest
status of the printer.
→
(2 or 3 seconds)
→
(2 or 3 seconds)
→
(2 or 3 seconds)
→
(3 sec.)
NOTE:
Please contact your authorized TOSHIBA TEC representative.
:LED off, :LED on, :LED blinking