Toshiba ASC25, Инструкция по эксплуатации

Страница: 33 / 41

32 ASC25 Instruction Manual
9.5 Method of F07optical connector assembly
Assembly work of optical connector shall conform to the following-given steps.
For detail, refer to the instruction manual attached to the assembly tools.
Precautions of optical connector assembly work
On assembling an optical connector, observe the following-listed
precautions.
•
Prepare exclusive-use assembling tools for processing
optical connector.
•
A simple training is necessary for the understanding of the
use of the exclusive-use assembling tools and for the
assembling method of optical connector.
For detail, inquire to the cable manufacturer.
Recommended optical connector assembling tools
Manufacturer: Sumitomo Electric Industries, Ltd.
Agency: Takachiho Electric Co., Ltd.
Model of optical connector assembling tools: CAK-1062
(1) Cut off about 110 to 150 mm of the edge portion of the optical fiber cable using a cutter
knife or other means, and inserts the optical fiber through the cord bush.
Optical fiber
Cord bush
110 to 150mm
Figure 9.9 Fiber cut off
(2) Using a jacket remover (use the hole at 2.2 side of label indication), remove the housing
to about 45 mm in length. At that moment, the step between two housings shall be within
1 mm.
Housing
45
±
2mm
Figure 9.10 Removal of housing