Toshiba 37X3030D, Руководство по обслуживанию

Страница: 18 / 225

After replacing QA02 or signal board, the following initialization is required.
1) Enter the service mode.
2) Select menu of ID by pressing P
or P during display of adjustment menu in the
service mode.
3) Change ID data into MODEL ID to initialize by pressing
+ or -., refer to table
below.
4) Press and hold the CALL button on the remote control, then press the CHANNEL
button on the TV.
5) Initialization progress dialog including model name and panel vendor is shown.
Progress status is "WRITING".
6) Progress status is changed "OK" and power cycle (automatically). Then QA02
initialization has been completed.
7) Enter the service mode and select version check mode. Confirm if model name and
model id set is correct. If not, repeat steps 1) to 6).
Note:
In case initialization by setting wrong MODEL ID is done, there is a possibility of
abnormal display.
8) Set I2C check function of TVOP to enable.
9) Check the picture carefully. If necessary, adjust any adjustment item above.
Perform "Auto tune" on the owner's manual.
CAUTION: Never attempt to initialize the data unless QA02 has been
replaced.
Whenever using new signal board to the set, setting the Model ID data
according to Panel option data.
MODEL ID (HEX) Model name Panel vendor
0x13 37X3000P LPL
0x14 42X3000P CMO
Page 8 of 20
18.01.2016 file://C:\Documents and Settings\Admin\Рабочий стол\37X3030D-03\37X3030D-03\...