Toshiba 37HL57, Руководство по обслуживанию

Страница: 18 / 139

Exit from Service Mode
Pressing POWER button to turn off the TV once.
Initialization of Memory Data of QA02 and Setting Data of Signal Unit
After replacing QA02 or signal board, the following initialization is required.
1) Enter the service mode.
2) Press and hold the CALL button on the remote control, then press the CHANNEL
button on the TV.
3) Check the picture carefully. If necessary, adjust any adjustment item above.
Perform "Auto tune" on the owner's manual.
Test Signal Selection
Every pressing of button on the remote control changes the built-in test patterns on
screen as described below in Service Mode.
CAUTION: Never attempt to initialize the data unless QA02 has been
replaced.
Whenever using new signal board to the set, setting the Adjusting Data.
Picture Signal
Стр. 8 из 18
08.05.2015 file://C:\Documents and Settings\Alexsandr\Local Settings\Temp\Rar$EXa0.108\37H...