Defining the INPUT and OUTPUT sockets so
that the television recognises connected
equipment. See page 6 for a clear view of the
back connection recommendations.
This specifies the type of signal going into SCART 2
(
EXT2
) on the back of the television. Please refer to the
manufacturers instructions for the connected equipment.
From the
Set up
menu select
EXT2 input
and with
S
or
R
select either
AV
or
S-VIDEO
as the required
input
.
Most VCRs and decoders send a signal through the
SCART lead to switch the television to the correct
Input
socket. Alternatively press the external source selection
button
B
until the picture from connected equipment is
shown.
An
S
in the display e.g.
EXT2S
, indicates the input is set
for an S-Video signal.
Press
B
to select
EXT1
,
EXT2
or
EXT3
.
To return to television mode press
B
again or
one of the numbered buttons.
Use the Input Selection if the television does not switch
over automatically.
Input selection
INPUT signal selection
1
1
2
If the colour is missing try the alternative setting.
Set up
EXIT
: To exit
Language
z
ENGLISH
x
Auto tuning
x
Manual tuning
x
Programme sorting
x
EXT2 input
z
AV
x
Horizontal position
z x
16
Press
Q
to select
Off timer
. Use the number
buttons to set the required time. For example, to
switch the television off in one and a half hours
enter 01:30, or use
S
and
R
to increase/decrease
in steps of 30 minutes.
Press
EXIT
to finish.
To turn the television back on press
i
or one of
the number buttons.
The timer, time display,
input selection and AV connections
The time display facility allows the current time to be seen
on the television screen.
Press
8
/
9
whilst watching a normal television
broadcast to see a time display from the broadcaster. It
will remain on screen for about 5 seconds.
The television can be set to turn itself
OFF
after a
certain time.
The Timer
The Time Display
1
2
3
Select
Timer
from the top menu bar.
Timer
0 – 9
: To set
EXIT
: To exit
Off timer
00:00