English
- 10 -
Initial Installation - Digital & Analogue
Before switching on the television put your decoder and media recorder to
Standby
if they are connected and ensure the
aerial is connected to your television. To set up the television use the buttons on the remote control as detailed on
page 4
.
Connect the mains plug and switch the TV into standby
1.
using the side On/Off switch. Press any numbered
or standby button on the remote control, then the
language selection menu will be displayed. This
screen will appear the first time that the television
is switched on and each time the television is reset.
By pressing the Up or Down buttons highlight the language
2.
you want to set and press OK button. Afterwards,the
following message will be displayed on the screen:
Select Yes by using Left or Right buttons and press
3.
OK
to continue. The Auto tuning screen will appear
and the television will start to search for available
stations. The progress bar will move along the line.
You must allow the television to complete the search.
A f t e r A u t o m a t i c S e a r c h i s c o m p l e t e d , t h e
4.
following message asking for analogue channel
search appears on the screen. Select Yes by using
Left or Right buttons and press
OK
to continue.
Select your Country, Language and Text language by
5.
using navigation buttons. Press
OK
or
RED
button
to continue. To cancel, press the
BLUE
button.
Note
:
For proper functioning of digital teletext in DTV mode, you
•
should set country as UK in analogue AUTO Programme
(for UK broadcasts only).
Do not turn off the TV while initializing first time
•
installation.
Auto Tuning
As new services are broadcast, it will be necessary to re-tune
the television in order to view them.
Auto Tuning will completely re-tune the television and can
be used to update the channel list. It is recommended that
Auto Tuning is run periodically to ensure that all new services
are added. All current channels and settings, i.e. locked
channels, will be lost.
Select the
•
SETUP
from the main menu by using
Up
or
Down
buttons. Press
OK
and Setup menu will be displayed.
Select the
•
Installation
from the Setup menu by using
Up
or
Down
buttons.
Press
OK
and Installation menu will be
displayed.
Select
•
Automatic Channel Scan
from the Installation menu
by using
Up
or
Down
buttons and press
OK
. A screen
will appear warning that previous digital programmes
and settings will be deleted. Select
Yes
and press
OK
to
continue with the
Auto tuning.
The television will start to search for all available stations.
•
You must allow the television to complete the search. When
the search is complete the
Auto tuning
screen will display
the total number of services found.
After search is completed for digital channels, a message
•
asking whether to search for analogue channels appears
on the screen:
Press the
•
OK
button to search for analogue channels.
The following menu appears on the screen for analogue
channel search:
00_MB45_[GB]_3910UK_IDTV_NICKEL9_19740W_(IB_INTERNET)_10068435.indd 10
00_MB45_[GB]_3910UK_IDTV_NICKEL9_19740W_(IB_INTERNET)_10068435.indd 10
17.05.2010 16:43:23
17.05.2010 16:43:23
