TorsionX
PWRPAX-AIR Multi-Port Power Pack (Updated 10/1/21)
6
Hydraulic Connections:
1.
Inspect all hydraulic twin line hoses, threads and fittings for signs of wear or damage
and replace as needed.
2.
Clean all hose ends and hydraulic couplers.
3.
Connect the twin line hydraulic hose to the hydraulic torque wrench and the power
pack, making sure all hydraulic couplers are snug.
4.
Jog the power pack several times.
a.
The power pack is now ready to be put into regular operation.
Adjusting the Hydraulic Pressure:
NOTE:
For easy adjustment of the pressure
regulating valve always adjust the pressure by
increasing to the desired pressure setting.
1.
Loosen the locknut on the pressure
regulating valve, and back the adjusting
knob out a few turns.
a.
Do so by turning the adjusting
knob in a counterclockwise
direction. (Figure 2)
b.
This will decrease the pressure setting to a pressure lower than the desired
pressure.
ATTENTION: THE POWER PACK MUST BE COMPLETELY CONNECTED AND THE HYDRAULIC
TORQUE WRENCH MUST NOT BE ON THE APPLICATION WHEN ADJUSTING THE PRESSURE.
2.
Connect the air supply, adjust the FRL pressure
on the 2” gauge to <100 psi and press the
activation button momentarily until the pump
turns on.
a.
The activation button the top button on
the remote located closest to the hoses.
3.
Once you have momentarily pressed and
released the top button the power pack should
turn and remain on.
a.
In this condition the power pack will
deliver hydraulic oil to the low-pressure port (Port B).
Figure 2
Figure 3
Activation
Off
