Toro Z590-D Z Master, Руководство оператора

Страница: 36 / 68

Engine Maintenance
Servicing the Air Cleaner
Note:
Service the air cleaner more frequently if
operating conditions are extremely dusty or sandy.
Removing the Filters
1. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Tilt the seat forward and remove the front engine
panel (Figure 43).
Figure 43
1. Front engine panel 2. Knob
4. Release the latches on the air cleaner and pull the air
cleaner cover off of the air cleaner body (Figure 44).
5. Clean the inside of the air cleaner cover with
compressed air.
6. Gently slide the primary filter out of the air cleaner
body (Figure 44). Avoid knocking the filter into the
side of the body.
7. Remove the safety filter only if you intend to replace
it.
Important:
Never attempt to clean the safety
filter. If the safety filter is dirty, then the primary
filter is damaged and you should replace both
filters.
8. Inspect the primary filter for damage by looking into
the filter while shining a bright light on the outside
of the filter. Holes in the filter will appear as bright
spots. If the filter is damaged discard it.
Figure 44
1. Latches
4. Primary filter
2. Air cleaner cover 5. Safety filter
3. Air filter body
Servicing the Primary Filter
Service Interval: Every 200 hours—Replace the
primary air filter.
1. Do not clean the paper filter, replace it (Figure 44).
2. Inspect the element for tears, an oily film, or damage
to the rubber seal.
3. Replace the paper element if it is damaged.
Servicing the Safety Filter
Service Interval: Every 600 hours—Replace the safety
air filter.
Do not clean the safety filter, replace it.
Important:
Never attempt to clean the safety filter.
If the safety filter is dirty, then the primary filter is
damaged and you should replace both filters.
Installing the Filters
Important:
To prevent engine damage, always
operate the engine with both air filters and cover
installed.
1. If installing new filters, check each filter for shipping
damage. Do not use a damaged filter.
2. If the safety filter is being replaced, carefully slide it
into the filter body (Figure 44).
3. Carefully slide the primary filter over the safety filter
(Figure 44). Ensure that it is fully seated by pushing
on the outer rim of the filter while installing it.
Important:
Do not press on the soft inside area
of the filter.
36