Toro Z400 Series Z-Master, Инструкции по установке

Страница: 4 / 12

Figure 6
2. Install the lanyard clips onto the long bolts
(1/2 x 3-1/4 inch).
Note:
Make sure the bent tab points toward
the head of the bolt.
Figure 7
3. Lightly oil the ends of the center roll bar
section.
4. Loosely install the center roll bar section using
2 bolts (1/2 x 3-1/4 inch) and 2 flange nuts
(1/2 inch).
Note:
Make sure the bolts are installed from
the outside of the roll bar.
Note:
Make sure the lanyard tab is installed
as show and points forward.
Figure 8
5. Raise the roll bar into the upright position and
secure it with the pins and hairpin cotter pins
fastened to the lanyards
Figure 9
6. Torque all lower fasteners, attached to the
machine frame, to 30 ft-lb.
7. Tighten the center roll bar bolts (1/2 x 3-1/4
inch) so it rotates freely with some resistance.
Note:
No more than one thread should be
exposed outside the nut.
4