Toro Z400 Series Z-Master, Инструкции по установке

Страница: 1 / 12

Form No. 3354-664 Rev A
Z400 Series Z Master® Mowers
Model No. For all Z400 Series Z Master Mowers
Setup Instructions
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step Description Qty. Use
1
No parts required
–
Remove parts from the crate.
2
No parts required
–
Check the tire pressure.
3
Rear wheels
2
Install the drive wheels.
Roll bar, right section 1
Roll bar, left section 1
Roll bar, center section
1
Bolt, (3/8 x 1 inch)
8
Curved washer 8
Flange nut, (3/8 inch) 8
Bolt, (1/2 x 3–1/4 inch) 2
4
Flange nut, (1/2 inch) 2
Install the Rollover Protection
System (ROPS).
5
Right control lever 1
Left control lever 1
Bolt (3/8 x 1 inch) (2 are assembled) 4
6
Curved washer (3/8 inch) (2 are
assembled)
4
Install the motion control levers.
7
No parts required
–
Adding fuel to the machine.
8
No parts required
–
Charge the battery.
Air cleaner cap 1
9
Hose clamp 1
Install the air cleaner cap.
10
Number 2 general purpose lithium
base or molybdenum base grease.
(Purchase separately.)
1 tube Check the machine for grease.
11
No parts required
–
Check the engine oil level.
12
No parts required
–
Prepare the side discharge chute.
13
No parts required
–
Check the machine before delivery
to the customer.
© 2005—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com. Original Instructions (EN)
Printed in the USA.
All Rights Reserved