Toro Z286E, Руководство оператора

Страница: 21 / 56

21
Driving Forward or Backward
The throttle control regulates the engine speed as
measured in rpm (revolutions per minute). Place the
throttle control in the fast position for best performance.
Always operate in the full throttle position when mowing.
Machine can spin very rapidly. Operator may lose
control of machine and cause personal injury or
damage to machine.
•
Use caution when making turns.
•
Slow the machine down before making sharp
turns.
Caution
Driving Forward
1. Release the parking brake; refer to Releasing the
Parking Brake, page 18.
2. Move levers to the center, unlocked position.
3. To go forward, slowly push the motion control levers
forward (Fig. 9).
Note: Engine will kill if traction control levers are moved
with parking brake engaged.
To go straight, apply equal pressure to both motion control
levers (Fig. 9).
To turn, move the motion control lever toward neutral in
the direction you want to turn (Fig. 9).
The farther you move the traction control levers in either
direction, the faster the machine will move in that
direction.
To stop pull the motion control levers to neutral.
4
m–2715
3
1
2
Figure 9
1. Motion control
lever—neutral lock
position 2. Center unlock position
3. Forward
4. Backward
Driving Backward
1. Move levers to the center, unlocked position.
2. To go backward, slowly pull the motion control levers
rearward (Fig. 9).
To go straight, apply equal pressure to both motion control
levers (Fig. 9).
To turn, release pressure on the motion control lever
toward the direction you want to turn (Fig. 9).
To stop push the motion control levers to neutral.
Stopping the Machine
To stop the machine, move the traction control levers to
neutral and move to locked position, disengage the power
take off (PTO), and turn the ignition key to off. Also set
the parking brake when you leave the machine; refer to
Setting the Parking Brake, page 18. Remember to remove
the key from the ignition switch.
Children or bystanders may be injured if they
move or attempt to operate the tractor while it is
unattended.
Always remove the ignition key and set the
parking brake when leaving the machine
unattended, even if just for a few minutes.
Caution
Adjusting the Height-of-Cut
The height-of-cut is adjusted from 1-1/2 to 5 in. (38 to
127 mm) in 1/4 in. (6 mm) increments by relocating clevis
pin in different hole locations.
Note: Press on lift assist pedal when raising deck. This
will help in lifting the deck (Fig. 12).
1. Press your foot on the lift assist pedal while raising the
height-of-cut lever to the transport position (also the
5 in. (127 mm) cutting height position) (Fig. 10).
2. To adjust, remove hairpin cotter and clevis pin from
height-of-cut bracket (Fig. 10).
3. Select hole in height-of-cut bracket corresponding to
the height-of-cut desired, and insert clevis pin
(Fig. 10).
4. Secure clevis pin with hairpin cotter (Fig. 10).
5. Move lever to selected height.