Toro Z149 Z Master 74411, Руководство оператора

Страница: 29 / 56

Installing the Filters
Important:
To prevent engine damage,
always operate the engine with both air filters
and cover installed.
1. If installing new filters, check each filter for
shipping damage. Do not use a damaged filter.
2. If the safety filter is being replaced, carefully
slide it into the filter body (Figure 28).
3. Carefully slide the primary filter over the safety
filter (Figure 28).
Note:
Ensure that it is fully seated by pushing
on the outer rim of the filter while installing it.
Important:
Do not press on the soft
inside area of the filter.
4. Install the air cleaner cover with the side
indicated as UP facing up and secure the
latches (Figure 28).
Servicing the Engine Oil
Service Interval/Specication
Change the engine oil as follows:
• After the first 8 operating hours
• After every 100 operating hours
Note:
Change the oil more frequently when
the operating conditions are extremely dusty
or sandy.
Oil Type: Detergent oil (API service SF, SG,
SH, or SJ)
Crankcase Capacity: 58 ounces (1.7 liter) with
the filter removed; 51 ounces (1.5 liter) without
the filter removed
Viscosity: Refer to the table below
Figure 29
Checking the Engine Oil Level
1. Park the machine on a level surface.
2. Disengage the PTO, turn the ignition key to
off, and remove the key.
3. Wait for all moving parts to stop before leaving
the operating position and then chock or block
tires.
4. Clean around the oil dipstick (Figure 30) so
that dirt cannot fall into the filler hole and
damage the engine.
Figure 30
1. Oil dipstick 2. Filler tube
5. Unscrew the oil dipstick and wipe the end
clean (Figure 30).
6. Slide the oil dipstick fully into the filler tube,
but do not thread onto tube (Figure 30).
7. Pull the dipstick out and look at the metal end.
If the oil level is low, slowly pour only enough
oil into the filler tube to raise the level to the
Full mark.
29