Toro Z-Master, Руководство оператора, Страница: 16 / 24

Operation
14
Dumping the Hopper
The hopper is equipped with a hopper full sensor that
checks for a full condition. When the alarm buzzer
sounds the hopper needs to be emptied.
1. Move the power take off (PTO) switch to off.
2. Move the traction unit so the hopper door is
where you want to dump the clippings, then
move the traction controls to neutral and set the
parking brake.
IMPORTANT: The hopper is interlocked
with the engine ignition and the engine will
stop if these steps are not followed before
dumping the hopper or getting out of the seat.
3. Unhook the door latches on the rear sides and
the hopper latch on the front left side of the
hopper (Fig. 23).
4. Open the door and lift up on the hopper at the
lower front and dump the clippings (Fig. 23).
2
m-3571
1
3
Figure 23
1. Door latch
2. Hopper latch
3. Lift here
5. Lower the hopper and secure the door latches on
the rear sides and the hopper latch on the front
left side of the hopper (Fig. 23).
IMPORTANT: Front left latch must be
secured to prevent hopper from accidently
tilting during transport.
Tilting the Mower
The mower can be tilted up for ease of service or to
shorten unit length for transport and storage.
To Raise Mower
1. Turn engine off, set the parking brake and check
that PTO cover is down against footrest
(Fig. 24).
2. Lift on the mower carrier frame to release weight
on latch pin and pull out on latch pin to release
(Fig. 24). Lower rear of mower onto anti-scalp
rollers. Repeat on the other side.
3. Return the pins to the spring loaded (down)
position.
m-3374
3
1
4
2
Figure 24
1. Parking brake
2. PTO cover
3. Latch pin
4. Notch–open