Toro Z Master Professional 5000 Series, Руководство оператора

Страница: 42 / 80

g012996
Figure 45
1. Air-inlet cover 3. Air-cleaner body
2. Air-inlet screen 4. Latch
6. Release the latches on the air cleaner and pull
the air-cleaner cover off the air-cleaner body
(
Figure 46 ).
7. Clean the inside of the air-cleaner cover with
compressed air.
8. Gently slide the primary filter out of the
air-cleaner body (
Figure 46 ).
Note:
Avoid knocking the filter into the side of
the body.
9. Remove the inner filter only if you intend to
replace it.
Important:
Never attempt to clean the inner
filter. If the safety filter is dirty, then the
primary filter is damaged. Replace both
filters.
g012997
Figure 46
1. Inner filter 4. Latch
2. Primary filter 5. Air-cleaner body
3. Air-cleaner cover
10. Inspect the primary filter for damage by looking
into the filter, while shining a bright light on the
outside of the filter.
Note:
Holes in the filter will appear as bright
spots. If the filter is damaged, discard it.
Servicing the Primary Filter
•
If the primary filter is dirty, bent, or damaged,
replace it.
•
Do not clean the primary filter.
Servicing the Safety Filter
Replace the safety filter, never clean it.
Important:
Do not attempt to clean the safety
filter. If the safety filter is dirty, then the primary
filter is damaged. Replace both filters.
Installing the Filters
Important:
To prevent engine damage, always
operate the engine with both air filters and the
cover installed.
1. If installing new filters, check each filter for
shipping damage.
Note:
Do not use a damaged filter.
2. If the inner filter is being replaced, carefully slide
it into the filter body (
Figure 46 ).
3. Carefully slide the primary filter over the inner
filter (
Figure 46 ).
42