Toro Z Master 75990, Руководство оператора

Страница: 27 / 72

g032377
Figure 26
Transport Lock Positions
1. Transport lock 3. U
NLOCK
position—the
mower deck is not locked
into the transport position
2. L
OCK
position—the
mower deck locks into
the transport position.
Adjusting the Height-of-Cut Pin
The height of cut is adjusted from 25 to 140 mm (1 to
5-1/2 inches) in 6 mm (1/4 inch) increments by moving
the clevis pin into different hole locations.
1. Move the transport lock to the L
OCK
position.
2. Push on the deck-lift pedal with your foot and
raise the mower deck to the transport position
(also the 140 mm (5-1/2 inch) cutting-height
position); refer to
Figure 27 .
3. To adjust, rotate the pin 90 degrees and remove
the pin from the height-of-cut bracket (
Figure
27 ).
4. Insert the pin into a hole that corresponds to the
desired height of cut (
Figure 27 ).
5. Push on the deck-lift pedal, pull back on the
transport lock, and slowly lower the mower deck.
g029840
Figure 27
1. Deck-lift pedal 3. Transport lock
2. Height-of-cut pin
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is
recommended to adjust the height of the anti-scalp
rollers.
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the neutral-locked
position, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers as shown in Figure
28 , Figure 29 , and Figure 30 .
27