Toro Z Master 74941CP, Руководство оператора

Страница: 28 / 68

Figure 36
1. Z Stand 4. Bottom of slot
2. Bracket Pin 5. Latch
3. Bracket
3. Raise the latch. Swing the stand foot out front and
slide stand toward machine, into the bottom of slot
(Figure 36 and Figure 37).
Figure 37
1. Z Stand (Positioned in
slot) 3. Latch resting on pivot tab
2. Crack in side walk or turf
4. Set the foot of stand on the ground and rest the
latch on the pivot tab (Figure 37).
5. Start the engine and put it at half throttle.
Note:
For best results, place the foot of stand into
seams in sidewalks or into the turf (Figure 37).
6. Drive onto the stand. Stop when the latch drops
over the tab into the locked position (Figure 37).
Once onto the stand, engage the parking brake and
tun off the engine.
7. Chock or block the drive wheels.
WARNING
Parking brake may not hold machine parked
on Z Stand and could cause personal injury or
property damage.
Do not park on Z Stand unless wheels are
chocked or blocked.
8. Perform the maintenance.
Driving off the Z Stand
1. Remove the chocks or blocks.
2. Raise the latch to the unlocked position (Figure 38).
Figure 38
1. Z Stand 3. Locked position
2. Latch 4. Unlocked position
3. Start the engine and place it at half throttle.
Disengage the parking brake.
4. Slowly drive backwards off of the stand.
5. Return the stand to its rest position (Figure 36).
Operating Tips
Fast Throttle Setting
For best mowing and maximum air circulation, operate
the engine at the fast throttle position. Air is required
to thoroughly cut grass clippings, so do not set the
height-of-cut so low as to totally surround the mower
by uncut grass. Always try to have one side of the
mower free from uncut grass, which allows air to be
drawn into the mower.
Cutting a Lawn for the First Time
Cut grass slightly longer than normal to ensure the
cutting height of the mower does not scalp any uneven
ground. However, the cutting height used in the past is
generally the best one to use. When cutting grass longer
28