Toro Z Master 74923, Руководство оператора

Страница: 15 / 68

3. Lower the roll bar to the down position (Figure 7).
Figure 7
1. ROPS knob 3. Roll bar in the upright
position
2. Pull ROPS knob out and
rotate 90 degrees 4. Roll bar in the folded
position
4. To raise the roll bar, raise the roll bar to the operate
position, rotate the knobs so they move partially
into the grooves (Figure 7).
5. Raise the roll bar to the full upright position while
pushing on the upper roll bar and the pins will snap
into position when the holes align with the pins
(Figure 7). Push on the roll bar and ensure that
both pins are engaged.
Important:
Always use the seat belt with the
roll bar in the raised position.
Think Safety First
Please read all safety instructions and symbols in the
safety section. Knowing this information could help
you or bystanders avoid injury.
Operating on wet grass or steep slopes can
cause sliding and loss of control.
Wheels dropping over edges can cause rollovers,
which may result in serious injury, death or
drowning.
There is no rollover protection when the roll
bar is down.
Always keep the roll bar in the raised and locked
position and use the seat belt.
Read and follow the rollover protection
instructions and warnings.
To avoid loss of control and possibility of
rollover:
• Do not operate near drop-offs or near water.
• Do not operate on slopes greater than
15 degrees.
• Reduce speed and use extreme caution on
slopes.
• Avoid sudden turns or rapid speed changes.
15