Toro Z Master 74919TE, Руководство оператора

Страница: 28 / 80

Adjusting the Height-of-Cut Pin
The height-of-cut is adjusted from 25 to 140 mm (1
to 5-1/2 inches) in 6 mm (1/4 inch) increments by
relocating the clevis pin into different hole locations.
1. Move the transport lock to the lock position.
2. Push on the deck-lift pedal with your foot, and
raise the mower deck to the transport position
(also the 140 mm (5-1/2 inches) cutting height
position) as shown in
Figure 29 .
3. To adjust, rotate the pin 90 degrees and remove
the pin from the height-of-cut bracket (
Figure
29 ).
4. Select a hole in the height-of-cut bracket
corresponding to the height-of-cut desired, and
insert the pin (
Figure 29 ).
5. Push on the deck lift, pull back on the transport
lock, and slowly lower the mower deck.
g027343
Figure 29
1. Deck-lift pedal 3. Transport lock
2. Cut-of-height pin
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is
recommended to adjust the height of the anti-scalp
rollers.
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
EUTRAL
-
LOCK
position, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers as shown in Figure
30 , Figure 31 , and Figure 32 .
g000942
Figure 30
1. Anti-scalp roller 4. Flange nut
2. Spacer
5. Bolt
3. Bushing
g000943
Figure 31
1. Anti-scalp roller 3. Flange nut
2. Bushing 4. Bolt
28