Toro Z-325, Руководство оператора

Страница: 28 / 44

Maintenance
26
6. Fill oil as in steps 1 and 2.
m-3294
1
2
3
4
Figure 22
1. Gearbox
2. Side plug
3. Top plug
4. Bottom plug
Cleaning the Cooling Systems
Before each use, check and clean cooling screen.
Remove any build–up of grass, dirt or other debris
from the oil cooler screen and engine air intake.
Every 100 hours clean oil cooler, engine cylinder and
cylinder head cooling fins. Also clean around
carburetor, governor levers and linkage. This will
help insure adequate cooling to hydraulic pumps,
motors and engine and will reduce the possibility of
overheating and mechanical damage.
1. To remove cooling screen remove lower bolts
and loosen top bolts. Slide screen down and
rearward to expose oil cooler (Fig. 23). Save all
mounting hardware.
2. Blow out fins of oil cooler and area between fins
and screen with compressed air. If area between
screen and fins is tightly packed, remove oil
cooler.
3. Clean off engine air intake (Fig. 23).
4. Install screen from rear and raise over oil cooler.
Secure with previously removed hardware
(Fig. 23).
ÑÑÑÑÑÑÑÑ
ÑÑÑÑÑÑÑÑ
ÑÑÑÑÑÑÑÑ
m–3296
3
1
2
3
4
2
Figure 23
1. Oil cooler screen
2. Lower bolts
3. Top bolts
4. Engine air intake
Tire Pressure
Maintain the air pressure in the front and rear tires as
specified. Uneven tire pressure can cause uneven cut.
Check the pressure at the valve stem after every 50
operating hours or monthly, whichever occurs first
(Fig. 24). Check the tires when they are cold to get
the most accurate pressure reading.
Pressure: 20 psi (83 kPa) drive wheels and 6 psi
(41 kPa) castor wheel.
1
m–1872
Figure 24
1. Valve stem