Toro z-252, Руководство оператора

Страница: 13 / 44

Assembly
11
Install Seat Retaining Rod
5. Tilt seat up. Remove 5/16” locknut from bolt
attaching seat retaining rod to seat frame
(Fig. 1).
6. Remove retaining rod from seat and insert the
”L” shaped end of the rod into the hole directly
above the left–side hydraulic pump mounting
hardware (the ”L” must be positioned to the
right) (Fig. 1).
7. Place the seat retaining rod to the outside of the
mounting tab of the seat frame and secure with
5/16–18 x 1” (26 mm) bolt and 5/16” locknut
(Fig. 1).
8. Tighten until snug, then loosen so the rod pivots
freely.
3
1
m–3750
2
Figure 1
1. L end of retaining rod
2. Locknut 5/16”
3. Bolt 5/16–18 x 1” (26 mm)
Tire Pressure
Check the air pressure in the front and rear tires
(Fig. 2).
Pressure: 13 psi (90 kPa)
1
m–1872
Figure 2
1. Valve stem
Front Weight Kit Safety
Requirement
POTENTIAL HAZARD
•
When operating the 52” mower attachment
without Front Weight E632802, the tractor
may become unstable.
WHAT CAN HAPPEN
•
Loss of traction and stability may cause
loss of tractor control.
HOW TO AVOID THE HAZARD
•
NEVER operate tractor, unless the Front
Weight E632802 is installed.
IMPORTANT: The tractor requires Front
Weight when equipped with a 52” Mower
Attachment.