Toro Workman HD Series, Руководство по обслуживанию, Страница: 86 / 318

Workman HD Series Page 6 -- 10 Drive Train
Service and Repairs
Shift Cable Replacement
1. Shift knob
2. Jam nut
3. Boot seal
4. Shift cable
5. Shift pin
6. Jam nut
7. Hair pin
8. Clevis pin
9. Shift lever
10. Shift link
11. Cable clevis
12. Cap screw
13. Lower shift boot
14. Lock nut
15. Lever support
16. Hex nut (2 used)
17. Shift stop bolt (2 used)
18. Screw (3 used)
19. Cable clamp
Figure 4
FRONT
RIGHT
5
1
4
3
2
9
11
10
7
6
18
8
12
13
15
17
16
14
10
7
8
6
11
4
19
Shift Cable Removal (Fig. 4)
1. Park vehicle on a level surface, raise and support bed
(if installed), shut engine off and engage the parking
brake. Remove key from the ignition switch.
2. Remove knobs from control levers, then remove cen-
ter console shift boot and control plate (Fig. 5).
3. Remove three (3) screws (item 18) and cable clamp
(item 19) that secure shift cables to lever support.
4. Remove hair pin and clevis pin that secure shift cable
clevis to shift link (item 10) on shifter in operator platform.
5. Loosen jam nut that retains clevis to shift cable and
remove clevis from cable.