Toro WORKMAN GTX 07131, Руководство оператора

Страница: 42 / 48

B. Add DOT 3 brake fluid to the reservoir until the
fluid level is above the Minimum line (
Figure 49 ).
Note:
Do not overfill the reservoir with brake
fluid.
C. Install the reservoir cap ( Figure 48 ).
5. Close the hood of the machine.
Inspecting the Brakes
Service Interval: Every 100 hours
Brakes are a critical safety component of the machine. As
with all safety components, they should be closely inspected at
regular intervals to ensure optimum performance and safety.
•
Inspect the brake shoes for wear or damage. If the lining
(brake pad) thickness is less than 1.6 mm (1/16 inch), the
brake shoes should be replaced.
•
Inspect the backing plate and other components for signs
of excessive wear or deformation. If any deformation is
found, the appropriate components must be replaced.
•
Check the brake-fluid level; refer to Checking the
Brake-Fluid Level (page 41) .
Replacing the Service and
Parking-Brake Pads
Service Interval: Every 400 hours
Contact your authorized Authorized Toro Service Dealer to
inspect and possibly replace the service and parking-brake
pads.
Changing the Brake Fluid
Service Interval: Every 1,000 hours
Contact your authorized Authorized Toro Service Dealer.
Chassis Maintenance
Adjusting the Cargo-Box
Latches
If the cargo-box latch is out of adjustment, the cargo box
vibrates up and down as you drive the machine. You can
adjust the latch posts to make the latches hold the cargo box
snugly to the chassis.
1. Verify that the cargo box is latching.
Note:
If the cargo box does not latch, the box-latch
striker is likely too low. If the cargo box latches, but
vibrates up and down as you drive, the box-latch striker
is likely too high.
2. Raise the cargo box; Raising the Cargo Box to the
Dump Position (page 18) .
3. Loosen the 2 bolts on the box-latch striker and move
the striker up or down, depending on if the striker is
too high or too low (
Figure 50 ).
Figure 50
1. Bolts 2. Box-latch striker
4. Tighten the 2 bolts on the box-latch striker ( Figure 50 ).
5. Verify that the adjustment is correct by latching the
cargo box several times.
42