Toro Workman 07235, Руководство оператора

Страница: 33 / 60

g027733
Figure 33
1. Air-filter housing 3. Air-filter cover
2. Air-filter element 4. Latch
3. Release the latches securing the air-filter cover
to the air-filter housing (
Figure 33 ).
4. Separate the air-filter cover from the air-filter
housing, and clean the inside of the cover
(
Figure 33 ).
5. Gently slide the air-filter element out of the filter
housing.
Note:
To reduce the amount of dust dislodged,
avoid knocking the filter against the air-filter
housing.
6. Inspect the air-filter element.
•
If the air-filter element is clean, install the
filter element; refer to
Installing the Air Filter
(page 33) .
•
If the air-filter element is damaged, replace
the filter element; refer to
Replacing the Air
Filter (page 33) .
Replacing the Air Filter
1. Remove the air-filter element.
2. Inspect the new filter for shipping damage.
Note:
Check the sealing end of the filter.
Important:
Do not install a damaged filter.
3. Install the new air filter; refer to Installing the Air
Filter (page 33) .
Installing the Air Filter
Important:
To prevent engine damage, always
operate the engine with the complete air cleaner
assembly installed.
Important:
Do not use a damaged element.
Note:
Cleaning of the used air-filter element is not
recommended due to the possibility of damage to the
filter media.
1. Clean the dirt ejection port located on the
air-filter cover.
2. Remove the rubber outlet valve from the cover,
clean the cavity, and replace the outlet valve.
3. Insert the air-filter element into air-filter housing
(
Figure 33 ).
Note:
Ensure that the filter is sealed properly
by applying pressure to the outer rim of the filter
when installing it. Do not press on the flexible
center of the filter.
4. Align the air-cleaner cover with the air-cleaner
housing (
Figure 33 ).
5. Secure the cover to the housing with the latches
(
Figure 33 ).
6. Lower the cargo box.
33