Set-Up Instructions
6
Check Traction Control Pedal
(Hydro Drive Tractors Only)
After adjusting the hydro neutral position it is
necessary to check the traction control pedal. While
pressing the control pedal full forward and full
reverse it must not contact the footrest pad before
hitting the stop(s) at the transaxle (Fig. 7).
1.
If contact is made with the foot pad, before
hitting stop(s) on transaxle (Fig. 7), in either
forward or reverse directions, adjustment is
required.
2.
Loosen the capscrews below the right footrest.
Slide the pedal in the slots away from the
direction that made contact with the footrest
(Fig. 8).
3.
Tighten capscrews and recheck traction control
pedal for contact with stop(s) on transaxle and
footrest.
1
2
1909
Figure 8
1.
Traction control pedal
2.
Adjusting capscrews
Check Shift Cable Adjustment
(Gear Drive Tractors Only)
Cable adjustment is required if the ground speed
selector lever does not move firmly toward the
numbers on the shift plate when released or it is
difficult to shift between gears on-the-go (Fig. 9).
1
2
1879
Figure 9
1.
Gear select lever
2.
Numbers
1.
If either of the above conditions exist, check that
belt guides are positioned no more than 1/8 inch
away from the engine and transmission pulleys.
2.
Check the cable tension. Cable should be taught
and have 1/2 inch movement with slight pressure
applied (Fig. 10).
Содержание WHEEL HORSE Series
Страница 8: ......
