Set-Up Instructions
2
Install Front Wheels
Note:
If wheels are already installed, refer to
Check Tire Pressure (below).
1.
Install wheel onto axle with valve stem out.
2.
Slide the flat washer onto the axle. Insert cotter
pin through the axle and bend the ends of the pin
apart (Fig. 1).
3.
Push the hub cap (Fig. 1) onto the end of the
axle.
1
2
3
Figure 1
1.
Flat washer
2.
Cotter pin
3.
Hub cap
4.
Repeat steps 1–3 on opposite side.
5.
Grease the wheel bearings.
Install Rear Wheels
1.
Grease the axle to prevent corrosion. Slide
spacer then wheel, with valve stem to the
outside, onto axle (Fig. 2).
2.
Slide key into keyway of axle and wheel hub
(Fig. 2).
3.
Slide washer onto axle and secure with E-ring
(Fig. 2).
4.
Press hub cap over washer (Fig. 2).
1779
1
3
5
6
7
4
2
Figure 2
1.
Axle
2.
Spacer
3.
Wheel
4.
Key
5.
Washer
6.
E-rung
7.
Cap
Check Tire Pressure
Check front and rear tire pressure. See Operator’s
Manual for specification.
