Toro TX 427 22342HD, Руководство оператора

Страница: 20 / 52

Using Attachments
Important:
If you are using an attachment with a
serial number of 200999999 or earlier, the manual for
the attachment may contain information specific to the
use of the attachment with other traction units, such as
settings for the flow divider control and speed selector
lever and the use of a counterweight on the traction unit.
These systems are built into the TX, and you should
ignore any references to them.
Installing an Attachment
Important:
Use only Toro-approved attachments.
Attachments can change the stability and the operating
characteristics of the traction unit. The warranty of the
traction unit may be voided if used with unapproved
attachments.
Important:
Before installing the attachment, ensure
that the mount plates are free of any dirt or debris and
that the pins rotate freely. If the pins do not rotate freely,
grease them.
1. Position the attachment on a level surface with enough
space behind it to accommodate the traction unit.
2. Start the engine.
3. Tilt the attachment mount plate forward.
4. Position the mount plate into the upper lip of the
attachment receiver plate (
Figure 20 ).
Figure 20
1. Mount plate 2. Receiver plate
5. Raise the loader arms while tilting back the mount plate
at the same time.
Important:
The attachment should be raised
enough to clear the ground, and the mount plate
should be tilted all the way back.
6. Shut off the engine.
7. Engage the quick-attach pins, ensuring that they are
fully seated in the mount plate (
Figure 21 ).
Important:
If the pins do not rotate to the
engaged position, the mount plate is not fully
aligned with the holes in the attachment receiver
plate. Check the receiver plate and clean it if
necessary.
Figure 21
1. Quick-attach pins (shown
in engaged position) 3. Engaged position
2. Disengaged position
WARNING
If you do not fully seat the quick-attach pins
through the attachment mount plate, the
attachment could fall off the traction unit,
crushing you or bystanders.
Ensure that your quick-attach pins are fully
seated in the attachment mount plate.
20