Side-Discharging the Clippings
Use the side discharge for cutting very tall grass.
Installing the Side-Discharge Chute
Important:
Ensure that the rear-discharge plug is in place before you recycle the clippings.
1.
Shut off the engine and wait for all moving parts to stop.
2.
Remove the grass bag if it is installed on the machine; refer to
Removing the Grass Bag (page 17)
.
3.
Insert the rear-discharge plug (A of
).
4.
Remove the side-discharge deflector by pulling up on the spring that holds the deflector in place and
removing the deflector (B and C of
).
5.
Install the side-discharge chute by pulling up on the spring, placing the chute over the opening, and
lowering the spring over the tabs on top of the discharge chute (D and E of
).
g235903
Figure 21
Removing the Side-Discharge Chute
To remove the side-discharge chute, reverse the steps in
Installing the Side-Discharge Chute (page 18)
.
18
Содержание TurfMaster HDX
Страница 7: ...3 Assembling the Grass Bag No Parts Required Procedure g238450 Figure 5 7...
Страница 37: ...Notes...
Страница 38: ...Notes...
Страница 40: ......
