Toro TRX-16, Оригинальное руководство пользователя

Страница: 32 / 52

1. Remove the battery from the machine; refer to
Removing the Battery (page 30) .
Important:
Never fill the battery with distilled
water while the battery is installed in the machine.
Electrolyte could be spilled on other parts and
cause corrosion.
2. Clean the top of the battery with a paper towel.
3. Remove the vent caps from the battery ( Figure 43 ).
4. Slowly pour distilled water into each battery cell until
the electrolyte level is up to the upper line (
Figure 43 )
on the battery case.
Important:
Do not overfill the battery because
electrolyte (sulfuric acid) can cause severe
corrosion and damage to the chassis.
5. Wait 5 to 10 minutes after filling the battery cells. Add
distilled water, if necessary, until the electrolyte level is
up to the upper line (
Figure 43 ) on the battery case.
6. Install the battery vent caps.
Charging the Battery
WARNING
Charging the battery produces gasses that can
explode.
Never smoke near the battery and keep sparks and
flames away from battery.
Important:
Always keep the battery fully charged
(1.265 specific gravity). This is especially important to
prevent battery damage when the temperature is below
0° C (32° F).
1. Remove the battery from the chassis; refer to Removing
the Battery (page 30) .
2. Check the electrolyte level; refer to Checking the
Battery Electrolyte Level (page 31) .
3. Make sure the filler caps are installed in the battery.
4. Connect a 3 to 4 amp battery charger to the battery
posts and charge the battery at a rate of 3 to 4 amperes
for 4 to 8 hours (12 volts).
Do not overcharge the
battery.
5. When the battery is fully charged, unplug the charger
from the electrical outlet, then disconnect the charger
leads from the battery posts (
Figure 44 ).
6. Install the battery onto the machine and connect the
battery cables, refer to
Installing the Battery (page 31) .
Note:
Do not run the machine with the battery
disconnected, electrical damage may occur.
Figure 44
1. Positive Battery Post 3. Red (+) Charger Lead
2. Negative Battery Post 4. Black (-) Charger Lead
Replacing the Fuses (Models
22973 and 22974)
There are 4 fuses in the electrical system. They are under the
control panel on the left side (
Figure 45 ).
Start Circuit 30 amp
Charge Circuit 25 amp
Cooler fan Circuit 15 amp
Headlight (optional) 15 amp
Figure 45
1. Fuse block
32