Toro TRX-16, Оригинальное руководство пользователя

Страница: 19 / 52

Starting and Stopping the
Engine
Starting the Engine
1. Move the throttle lever midway between Slow and Fast
positions (
Figure 19 ).
G007809
1
2
3
Figure 19
1. Throttle lever 3. Key
2. Choke lever
2. Move the choke lever to the On position ( Figure 19 ).
Note:
A warm or hot engine may not require choking.
3. Start the engine as follows for your model:
•
For model 22972, turn the key to the On position
then pull the recoil handle on top of the engine.
•
For an electric start model, turn the key to the
On position (
Figure 19 ). When the engine starts,
release the key.
Important:
Do not engage the starter for more
than 10 seconds at a time. If the engine fails
to start, allow a 30 second cool-down period
between attempts. Failure to follow these
instructions can burn out the starter motor.
4. Gradually move the choke lever to the Off position
(
Figure 19 ). If the engine stalls or hesitates, engage the
choke again until the engine warms up.
5. Move the throttle lever to the desired setting ( Figure
19 ).
Important:
If the engine is run at high speeds
when the hydraulic system is cold (i.e., when the
ambient air temperature is near freezing or lower),
hydraulic system damage could occur. When
starting the engine in cold conditions, allow the
engine to run in the middle throttle position for
2 to 5 minutes before moving the throttle to fast
(rabbit).
Note:
If the outdoor temperature is below freezing,
store the machine in a garage to keep it warmer and
aid in starting.
Stopping the Engine
1. Move the throttle lever to the Slow position ( Figure 19 ).
2. Lower the boom ( Figure 20 ).
Figure 20
3. Turn the key off ( Figure 19 ).
Note:
If the engine has been working hard or is hot,
let it idle for a minute before turning the ignition key
off. This helps cool the engine before it is stopped. In
an emergency, the engine may be stopped immediately.
4. Remove the key.
Stopping the Machine
To stop the machine, release the traction control, move the
throttle lever to slow (turtle), lower the boom to the ground,
and stop the engine. Set the parking brake and remove the key.
CAUTION
A child or untrained bystander could attempt to
operate the machine and be injured.
Remove the key from the switch when leaving the
machine, even if just for a few seconds.
Moving a Non-functioning
Machine
Important:
Do not tow or pull the machine without first
opening the tow valves, or the hydraulic system will be
damaged.
1. Stop the engine.
2. Remove the bottom shield.
3. Using a wrench, turn the tow valves on the hydraulic
pumps twice counter-clockwise (
Figure 21 ).
19