2
Setting Up the Motion Control Levers and the Seat
No Parts Required
Procedure
1. Remove the upper bolt (3/8 x 1 inch) and washer; loosen the lower bolt (3/8 x 1 inch) as shown in Figure 2.
2. Align the holes in the motion control lever with the holes in the control arm shaft and install the bolt and washer
removed previously (Figure 2). Hand tighten all fasteners. Repeat this for both controls levers. Move the
motion control levers into the neutral lock position.
G010256
Figure 2
3. Setup the seat as follows (Figure 3):
G010258
A
B
C
D
C
C
Figure 3
A. Remove the hairpin cotters on the seat rod securing the seat to the machine.
2