Toro TITAN MAX 76601, Руководство оператора

Страница: 46 / 64

g036859
Figure 56
1. Idler pulley 4. Pump-drive belt
2. Idler-spring post 5. Right hydraulic-pump
pulley
3. Engine pulley
6. Left hydraulic-pump pulley
9. Install the clutch stop ( Figure 55 ).
10. Install the mower belt; refer to Belt Maintenance
(page 44) .
Controls System
Maintenance
Adjusting the
Control-Handle Position
If the ends of the levers hit against each other, refer
to
Adjusting the Height (page 46) .
Adjusting the Height
You can adjust the motion control levers higher or
lower for maximum comfort.
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the hardware holding the control lever
to the control-arm shaft.
g035858
Figure 57
1. Bolts 3. Control lever
2. Slotted hole 4. Control-arm shaft
4. Move the control lever to the next set of holes.
Secure the lever with the hardware.
5. Repeat the adjustment for the opposite control
lever.
46