Toro TITAN HD 1500, Руководство оператора, Страница: 78 / 88

Note:
If the blade is not balanced, file some
metal off the end of the sail area only ( Figure
118 ).
g000553
Figure 119
1. Blade 2. Balancer
3. Repeat this procedure until the blade is
balanced.
Leveling the Mower Deck
Check to ensure that the mower deck is level any time
you install the mower or when you see an uneven cut
on your lawn.
Check the mower deck for bent blades prior to
leveling, and remove and replace any bent blades;
refer to the
Servicing the Cutting Blades (page 74)
before continuing.
Level the mower deck side-to-side first; then you can
adjust the front-to-rear slope.
Requirements:
•
The machine must be on a level surface.
•
All tires must be properly inflated; refer to Checking
the Tire Pressure (page 63) .
Adjusting the Side-to-Side
Leveling and the Blade Slope
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Check the tire pressure in the drive tires. Refer
to
Checking the Tire Pressure (page 63) .
4. Position the mower deck in the transport-lock
position.
5. Carefully rotate the blades from side to side.
6. Measure between the blade tip and the flat
surface (
Figure 120 ). If the measurements are
not within 5 mm (3/16 inch), adjust the leveling;
continue with this procedure.
g229303
g229305
Figure 120
1. Blades side to side
3. Measure from the tip of the
blade to the flat surface
here.
2. Blade tip
7. Check the front-to-rear blade level ( Figure 121 ).
Ensure the front blade tip is lower than the rear
blade tip as shown in the block height and rake
table. If it needs adjustment, continue with this
procedure.
g229304
Figure 121
1. Blades front to rear 3. Measure from the tip of the
blade to the flat surface
here.
2. Blade tip
78