Toro TITAN HD 1500, Руководство оператора

Страница: 67 / 88

g036865
Figure 95
2500 Series Mower Decks
1. Clutch pulley 4. Ratchet
2. Mower belt 5. Square hole in the idler
arm for the ratchet
3. Spring-loaded idler pulley
8. Install the idler spring ( Figure 93 or Figure 95 ).
Note:
Seat the spring ends in the anchor
grooves.
9. Install the belt covers ( Figure 96 ).
g027730
Figure 96
Replacing the Mower Belt
for Rear-Discharge Mower
Decks
Replacing the Counter-Rotating
Belt
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Lower the mower to the 76 mm (3 inches) height
of cut.
4. Lift the floor pan up to gain access to the center
pulley.
5. Remove the plastic belt cover ( Figure 98 ).
6. Remove the 3 bolts holding the metal belt cover
in place and remove the metal belt cover.
g024145
Figure 97
1. Idler spring 4. Idler pulley
2. Counter-rotating belt 5. Square hole in the idler
arm for the ratchet
3. Double pulley
7. Use a ratchet in the square hole in the idler arm
to remove tension on the idler spring (
Figure 97 ).
8. Remove the belt from the mower deck pulley
(
Figure 97 ).
67