Toro TITAN 74861, Руководство оператора, Страница: 52 / 60

Cleaning
Washing the Underside of
the Mower
Service Interval: After each use—Clean the mower
housing.
Wash the underside of the mower after each use to
prevent grass buildup for improved mulch action and
clipping dispersal.
1. Park the machine on a level surface and
disengage the blade control switch.
2. Move the motion control levers outward to the
neutral lock position, stop the engine, remove
the key, and wait for all moving parts to stop
before leaving the operating position.
3. Attach the hose coupling to the end of the
mower washout fitting, and turn the water on
high (
Figure 72 ).
Note:
Spread petroleum jelly on the washout
fitting O-ring to make the coupling slide on
easier and protect the O-ring.
g010344
Figure 72
1. Washout fitting locations
on 54 inch decks 4. O-ring
2. Washout fitting locations
on 48 and 60 inch decks 5. Hose
3. Washout fitting 6. Coupling
4. Lower the mower to the lowest height-of-cut.
5. Sit on the seat and start the engine. Engage the
blade control switch and let the mower run for 1
to 3 minutes.
6. Disengage the blade control switch, stop the
engine, and remove the ignition key. Wait for all
moving parts to stop.
7. Turn the water off and remove the coupling from
the washout fitting.
Note:
If the mower is not clean after one
washing, soak it and let it stand for 30 minutes.
Then repeat the process.
8. Run the mower again for one to three minutes to
remove excess water.
52