Toro TITAN 74861, Руководство оператора

Страница: 49 / 60

g020312
Figure 66
1. Spring removal tool (Toro
part no. 92-5771) 4. Idler arm
2. Idler spring 5. Mower belt
3. Deck post
7. Lower the mower to the lowest height-of-cut.
8. Place the height-of-cut pin in the lock position
for lowest height-of-cut.
9. Remove the belt from the mower deck pulleys
and remove the existing belt.
Installing the Belt
1. Install the new belt around the mower pulleys
and the clutch pulley under the engine (
Figure
66 ).
2. Using a spring removal tool (Toro part no.
92-5771), install the idler spring over the deck
post and place tension on the idler pulley and
mower belt (
Figure 66 ).
3. Ensure that the belt is properly seated in all
pulleys.
4. Install the belt covers ( Figure 67 ).
g020313
Figure 67
1. Position the belt cover and
ensure that the tabs seat. 3. Tighten the screws
2. Pivot the belt cover down
Removing the Mower
Park the machine on a level surface and disengage
the blade control switch. Move the motion control
levers outward to the neutral position, engage parking
brake, stop the engine, remove the key, and wait for
all moving parts to stop before leaving the operating
position.
Lower the mower to the lowest height-of-cut. Select
one of the following procedures depending on the
mower deck size installed to complete the removal.
Preparing to Remove the Mower
Deck
1. Lower the mower to the 76 mm (3 inch)
height-of-cut position.
2. Remove the mower belt from the engine pulley;
refer to
Removing the Belt (page 48) .
49